Dysun Energy | SmartgridOne Documentation

Supported Devices

Device Type	Variants	Modbus TCP (Ethernet)	RS485	Curtailment
Hybrid inverter	Dysun Hybrid	✅	✅	❌
FlexAmp	FlexAmp One 3.6K, 5K, 8K, 10K, 12K	❌	✅	✅

For correct RS485 wiring: follow the RS485 wiring guidelines.
If the wiring shown in the table below is incorrect, please let us know.
There is no general industry consensus on the use of A and B for RS485 polarity, so the naming may be counterintuitive for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
RS485-A	RS485 A	RS485_POS	RS485 A	TX+
RS485-B	RS485 B	RS485_NEG	RS485 B	TX-
GND	RS GND	GND	Not available	G

Serial settings:

Parameter	Value
Baud rate	9600 (default) or as configured in the inverter menu
Data bits	8
Parity	None
Stop bits	1

The FlexAmp series communicates exclusively over RS485.

For correct RS485 wiring: follow the RS485 wiring guidelines.
If the wiring shown in the table below is incorrect, please let us know.
There is no general industry consensus on the use of A and B for RS485 polarity, so the naming may be counterintuitive for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
RS485-A	RS485 A	RS485_POS	RS485 A	TX+
RS485-B	RS485 B	RS485_NEG	RS485 B	TX-
GND	RS GND	GND	Not available	G

Serial settings:

You MUST give each device a unique address on the RS485 bus. Check the device manual for instructions.
Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
For each device, it is generally recommended to keep the factory-default baud rate, parity, and stop bits. The SmartgridOne Controller will scan those first.

During device scanning or manual configuration, you will be prompted:

"What is included in the installation?"

Option	When to select
Solar panels and battery (default)	Both PV and battery are installed
Only solar panels	No battery is present
Only battery	No PV is present

Select the option that matches your installation. An incorrect selection will result in missing or incorrect measurements.

The inverter supports battery control:

Charge mode: Set charge current in amperes
Discharge mode: Set discharge power as a percentage of nominal power
When smart grid control is disabled, the inverter returns to autonomous operation

Experimental Control features for the Dysun Hybrid have not been validated on live hardware.

The FlexAmp series supports PV curtailment — the controller can limit the maximum solar production power in real time.

The active power limit is written as a percentage of nominal power.
When smart grid control is disabled, the device reverts to its configured local settings (typically unrestricted output).
Curtailment applies to the total production of all connected PV strings.